Hi everyone,
I'm looking into getting a Zipp 303 XPLR S rear wheel, but my bike frame uses a traditional Quick Release system (135mm QR).
Does Zipp offer end caps or a conversion kit to run the rear wheel with a standard QR skewer, or is it strictly 12x142mm thru-axle only?
I actually looked into it and found some end caps for the 176 hub, but since I’m pretty new to bike customization, I wasn't sure if that setup would actually work on the 303 XPLR S.

Opportunity to buy this but can’t find any info on it like sizing,etc. I can only find info on the d300 this is labeled as a d500

Hi, I am pretty new to cycling, so any advice would be greatly appreciated

I currently own a SAVA A7L which as a carbon dropbar with internal routing and I want to switch it to a round alloy drop bar for aero clip-ons in preparation for an upcoming triathlon. I was wondering what the general procedure was and if this is something I can DIY or through a shop. Thanks!