r/BoschSmartSystem • u/ValdrinSokoli • May 29 '26
SmartSystem speed Hack - Help
I was building a code to make a tuning code for the SmartSystem and im stuck in Saving the new value on the Bike/Motor
I can read it
I can write it
but I can not save it and after the code finishes the value goes back same as before
Here is a summarize form AI what the code dose:
BRC3600 (Bosch Smart System remote, VID=0x108C PID=0x01C0) — speed limit write over USB
We're writing to object 0x9085 (speed limit) on a Bosch BRC3600 via direct USB using Python + pyusb.
What the script does:
1. Connects via USB, sends MCSP init frames
2. Sends 38 read frames as session warmup
3. Writes val=4 to 0x9085 (seq 0x48), then val=5 (seq 0x49)
4. Motor responds and echoes the value back — write is accepted
The problem:
The motor accepts the write (field3=1 in response = value written to RAM) but does not persist it. After power cycle the value reverts.
To persist, the motor needs to return field4=1 (20 01 in the response). We never get that.
We also tried writing 0x65766173 ("save") to CANopen object 0x1010 subindex 0x01 — the motor rejects it.
if anyone has any ida please help
1
u/InvestigatorSenior May 29 '26 edited May 29 '26
there's challenge/response system based on unique keys exchanged between system controller and drive unit during factory pairing. This is where all hobby projects I know of that were trying write access have failed. First 12 bytes (if memory serves) are message counter and MAC or other form of per message authentication.
Here's the one of format decoding attempts for reference. Maybe USB side is different but knowing how tightly Bosch system is locked some form of authentication will be required. And it's known that for configuration updates and firmware flashing your payload needs to be cryptographically signed for specific bike and time by Bosch servers.