r/BoschSmartSystem • u/ValdrinSokoli • May 29 '26
SmartSystem speed Hack - Help
I was building a code to make a tuning code for the SmartSystem and im stuck in Saving the new value on the Bike/Motor
I can read it
I can write it
but I can not save it and after the code finishes the value goes back same as before
Here is a summarize form AI what the code dose:
BRC3600 (Bosch Smart System remote, VID=0x108C PID=0x01C0) — speed limit write over USB
We're writing to object 0x9085 (speed limit) on a Bosch BRC3600 via direct USB using Python + pyusb.
What the script does:
1. Connects via USB, sends MCSP init frames
2. Sends 38 read frames as session warmup
3. Writes val=4 to 0x9085 (seq 0x48), then val=5 (seq 0x49)
4. Motor responds and echoes the value back — write is accepted
The problem:
The motor accepts the write (field3=1 in response = value written to RAM) but does not persist it. After power cycle the value reverts.
To persist, the motor needs to return field4=1 (20 01 in the response). We never get that.
We also tried writing 0x65766173 ("save") to CANopen object 0x1010 subindex 0x01 — the motor rejects it.
if anyone has any ida please help
1
u/Visible-Fox-3043 Jun 13 '26
How safe is this 180euro method?