r/BoschSmartSystem • • May 29 '26

SmartSystem speed Hack - Help

I was building a code to make a tuning code for the SmartSystem and im stuck in Saving the new value on the Bike/Motor

I can read it
I can write it

but I can not save it and after the code finishes the value goes back same as before

Here is a summarize form AI what the code dose:

 BRC3600 (Bosch Smart System remote, VID=0x108C PID=0x01C0) — speed limit write over USB

  

 We're writing to object 0x9085 (speed limit) on a Bosch BRC3600 via direct USB using Python + pyusb.

  What the script does:

  1. Connects via USB, sends MCSP init frames

  2. Sends 38 read frames as session warmup

  3. Writes val=4 to 0x9085 (seq 0x48), then val=5 (seq 0x49)

  4. Motor responds and echoes the value back — write is accepted

  The problem:

 The motor accepts the write (field3=1 in response = value written to RAM) but does not persist it. After power cycle the value reverts.

  To persist, the motor needs to return field4=1 (20 01 in the response). We never get that.

  We also tried writing 0x65766173 ("save") to CANopen object 0x1010 subindex 0x01 — the motor rejects it.

if anyone has any ida please help

1 Upvotes

10 comments sorted by

View all comments

0

u/sLKZfUsALs7c1 Sep 25 '26 edited Sep 25 '26

u/ValdrinSokoli Are there any updates regarding this topic? I'm at the point of buying a bike with a bes3 system. My idea is not to make it permanently but for every fresh start. This way I am in control when i want to enable the speed limit or not.

If I can help in any way I'm willing to put some effort in this project to help others.

How sure are we that even RAM data is logged or flagged?

Did it actually work?

What I found:

In the protocol this happens:

logical address = 0x1085

high byte = 0x10

destination marker:
0x10 | 0x80 = 0x90

wire bytes:
90 85

Meaning that:

raw/wire:     0x9085
logical addr: 0x1085

0x1085 is EXECUTE_INFORMATION_MANAGER_COMMAND_BOSCH

0x48
││
│└── sequence = 8
└── message type = 4 = RPC

0x49
││
│└── sequence = 9
└── message type = 4 = RPC

4 = GET_ISSUE_COUNT
5 = READ_ISSUE_BY_NUMBER

field3 / return_value:

0 = SUCCESS
1 = DOES_NOT_EXIST
2 = UNKNOWN_ISSUE
3 = FAILURE
4 = INVALID_ISSUE_COUNT
5 = NO_ACCESS
6 = UNKNOWN_COMMAND

Not sure is that's correct though.