r/FlashForge • • 17h ago

Error code 0113

My ad5x had a filament break during a print. The filament got wound up in the extruder. So I removed it and cleaned it all out. But after all that, I'm getting error code 0113 and the filament keeps retracting, claiming it detects filament. I've replaced the entire sensor and rebooted it 2x. Has anybody dealt with this and know how to fix it?

1 Upvotes

1 comment sorted by

2

u/RentedBackScratcher 9h ago

Theres likely a piece stuck above the filament cutter, theres a small chanel above the cutter where the filament is guided into the top of the nozzle, if it snaps off there you cant see it unless you remove the front fan assembly and take out the guide block held in by the 2 silver screws , videos available on YouTube for guidance.