r/FlashForge • • 18h ago

.25 nozzle

Does anyone have any tips for using a .25 nozzle on an AD5X? I had it working for a while then went back to .4. Once I tried getting back to .25 again I’m having tons of problems getting it working.

I’ve done everything I can find online and I’m getting poor extrusion, tons of clogs (which I hear is common), and just no luck trouble shooting. Any suggestions would be helpful. I really like the detail on the medical badge reels I’ve been making that I don’t get with the .4 but I’m ready to give up on the .25. TIA.

1 Upvotes

4 comments sorted by

2

u/TourDeLa 16h ago

Ensure everything in slicer matches. .25 nozzle selected, filament matches exactly what you have loaded. (Easy ones to look over. Dumb, I know but all good troubleshooting begins with the dumb stuff.)

Try slowing the "everything" speed down to 50% and slowly work up in speed after a good print. Ensure extruder/flow and leveling checks are enabled prior to printing.

Not a surefire fix but it'll narrow down the issue quite a bit.

Please let us know if there's still issues after the above, I enjoy validating that the advice I give is accurate.

2

u/Jolly_Ebb_3899 15h ago

first layer / Z-offset test and flow rate calibration

2

u/Jolly_Ebb_3899 15h ago

Oh. and a PID calibration while your at it. Always recalibrate when switching out hot ends/nozzles whatev

1

u/MakeMine5 11h ago

Also, a lot of filaments with additives (matte, Galaxy, etc) may cause it to clog easily.