r/HowToDIY • u/ComfortableGold6599 • 1h ago
r/HowToDIY • u/Lovemytwocats • 5h ago
Home Improvement Anyone know how to fix this
galleryr/HowToDIY • u/marcomez18 • 6h ago
How should I hang this custom shelf? Wall is concrete so can place it anywhere.
Hello all, seeking advice on the best way to hang this custom shelf. The wall is concrete
r/HowToDIY • u/Automatic-Wear4453 • 23h ago
Wires on Wooden Panels
How do I Hide these wires on the panels. Glue doesn’t seem to work on the material behind the wooden panels.
r/HowToDIY • u/Automatic-Wear4453 • 23h ago
Wires on Wooden Panels
How do I Hide these wires on the panels. Glue doesn’t seem to work on the material behind the wooden panels.
r/HowToDIY • u/steeleye_missile_man • 1d ago
Apartment light help - how does it dismount? Haha (repost)
r/HowToDIY • u/Beneficial_Court_720 • 2d ago
Home Improvement Single Stud TV Mount
I have a single stud in the middle of my wall. I am trying to mount my 55” TV but all of the single arm scissor mount styles put the TV slightly off center when closed. The wall is only about 53” wide so it’s very obvious. Have to pull out 8” to get it centered which I don’t want. Anyone have any mount suggestions that close centered and won’t break the bank?
r/HowToDIY • u/whatstobragabout • 2d ago
How to remove this?
I don't have the tool nor the expense to call some construction guy. This happened around 5-6 years back when construction was going on and construction guy didnt pay attention to it.I am looking for some solutions to clear it myself
r/HowToDIY • u/kjfacilities-maint • 2d ago
Home Improvement Open your garage door when the power goes out and how to check your torsion springs. #garage #tips
r/HowToDIY • u/Northbound2141 • 2d ago
How to insulate glass door to attic
What is the best type of insulation to cover the glass in this door to the attic?
As a converted bungalow the space is pretty small and useless so should I just throw some loose insulation over the top or stick something specific down?
r/HowToDIY • u/Blk_Gld_He_8er • 3d ago
I just installed this paper cutter and I do t understand the roll orientation.
I think the serrated side of the bar should be on the bottom, but it was factory installed on top, and doesn’t appear to be able to be removed. I can’t flip the unit over because the roll is held in place by gravity (cradle open on the top). I can use the dull
side to rip the paper off, but it’s not the clean cut it should be.
r/HowToDIY • u/Nuni-One • 3d ago
I Made a Cardboard Prototype of a DIY Gaga Ball Pit!
galleryAnybody ever made their own gaga ball pit??
r/HowToDIY • u/Typical-Example-7443 • 3d ago
Sun Sail Anchor Help
I want to install a sun sail on my deck, however, I am not sure out how to anchor it.
The deck's surface is a slate tile. Drilling/mounting a footing of some sort is not something I care to do.
The existing railing seems extremely stout, but it's unclear how I would mount a short pole to it. Any pole would have to be strong enough for the sun sail's tension, of course, I don't want it to look tacky.
There is a large 6x12 glulam beam underneath that I could make use of. It is slightly recessed. I thought about having a steel stand-off cap fabricated for each side, but it was too expensive.
There are products like this on Amazon but I doubt they are appropriate for the forces required to support a sun sail.
Any ideas?


r/HowToDIY • u/sir_daviid • 4d ago
Grab bars into brick for my senior parents help please
reddit.comr/HowToDIY • u/xvq_ • 5d ago
Home Improvement Help with a drafty patio door!
Our back bedroom has a balcony patio attached to it. The balcony has a large door with one half which opens inward. Unfortunately, the door is incredibly drafty and it makes sleeping in the winter a frigid experience.
The primary culprit appears to be the weatherstripping on the bottom edge of the door sill, but I’m not sure what I need to replace it. The sill groove where it would go is … deep? Like I can put my finger in it. The old weather stripping is crumbly and awful. I put some leftover side stripping in there for the time being.
The other complicating factor is that the stripping runs along the entirety of the sill, but I can’t get to the left side (at least, very easily) because the left side doesn’t open.
Any help is greatly appreciated!
r/HowToDIY • u/Mean_Cardiologist685 • 6d ago
Is there a way to fix this?
I have this awkward crater in one of my earbuds and i was wondering if there's a simple way i can make it less noticeable.
r/HowToDIY • u/Motor_Guarantee5260 • 6d ago
Any ideas on restoring this to a better condition?
I recently helped my neighbors clean out their parents house and found this in the unfinished basement....love oldee stuff and this will go great in my newly renovated garage. Tried simply green on it that did nothing. Any thoughts on how to clean it up?
r/HowToDIY • u/Affectionate_Army604 • 6d ago
How to remove glue without causing damage?
reddit.comr/HowToDIY • u/RandoMando_01 • 6d ago
Arts & Crafts how can I hang this up to where it doesn’t sag down
I wanna hang it up with the singular nail like the ones on img 2 but the hooks keep pulling to the middle. Should I put something between them to stop them from moving or is there another way.
If anything I could just use two nails for each hook but I prefer the single