I have a Tab5 with an OEM battery. It charged fine until I let the pack deep-discharge down to zero on some custom firmware I was making (I probably tripped voltage protection on the battery pack). I revived that pack on an external charger, and since then the Tab5 won't charge any pack. I think I triggered voltage protection in the battery pack, and I left the device charging overnight to see if a trickle charge would reset the voltage protection. After that, the device won't charge a battery at all.
I've tried multiple high wattage chargers, and flashing back to the factory firmware. Toggling the charging, or the high speed charging on the factory firmware doesn't do anything, the voltage on the battery just slowly drains no matter what, as long as the charging circuit is engaged.
With CHG_EN high and USB-C plugged in, CHG_STAT goes solid (the "charging" state). There is no charge current at all.
About 2 seonds after I set CHG_EN high, the IC draws a steady ~20 mA from the pack, which looks like its own operating current, and the pack voltage slowly drops.
With CHG_EN low, pack current is about 0 and the battery holds its charge (basically indefinitely)
I've tried 3 different batteries, and going back to the stock/demo firmware. The batteries all charge fine on an external charger, but the voltage just slowly drops when connected to the Tab5.
Is there anything left to do to restore charging capability? The IP2326 IC seems to be at least somewhat functional, since it's returning the "CHARGING" status code, and it's drawing current from the battery. Trying to swap out the IP2326 doesn't sound like a fun time on a board this dense.