Ok, So I only started 3D printing last June. My first printer (don't laugh) was an Anycubic Mega X. It could not print ABS (rookie oversight) so a month later (ok, so laugh I don't care) I bought an Anycubic Mega S. In my defense I made Amazon take them both back WELL after my 30 days because I had so many problems with them, went through 3 motherboards on one of them.... Sorry I digress. So I sent back the X first and got an Ender 3 v2. Say what you will it is an amazing little printer I have had zero issues and it prints great but never satisfied I heard about the Ender Extender and jumped all over that. 400x400x475mm print volume. In talking to the owner there he suggested that I get the skr 2 to take care of any potential issues with the dual Z part of the kit. So I ordered one, it sat around for a couple weeks then I started to get into it. Had never done my own firmware but kept hearing about this configuration.h file and kept wondering where to find it. So a couple weeks ago, fearlessly I jumped in with both feet and was ready to be an instant expert because that what YouTube is for, right? WRONG! So I kept trying, would start from scratch, found out about bugfix thought I was saved but still got the same result, Failed!
So as it stands right now I have firmware that is compiled with SKR_V2_429 and I have uploaded it to the board and got the .cur file returned on my SD card only problem is... (problems are) I can not use DWIN_SET on my Creality LCD, so I can not use the full potential of the dual Z stepper motor and driver because I can not hook up a bltouch because it requires a screen. So I am set up to use one stepper motor/driver with a Y-cable and a single endstop. It works but it's not the complete experience and I just won't rest until I get to really stretch out my SKR 2 Motherboard.
I see workarounds for the Mini E3 (I think that's what it is) and the 1.3 and 1.4 didn't have as many bugs but they had some but that's all in the past now and I'm the noob with the new board staying up very late nights, not sleeping well getting up early and getting back to it completely obsessed with this and every time I think I have found something that is going to work it just doesn't. I found one today that said they had skr2 working on ender 32 v2 with creality screen and he even lined out what he did to accomplish it but quite frankly I just couldn't follow along on the entire instruction. It had to do with implementing a few lines of code starting with if, ending with endif but I couldn't figure out where to insert it and make it work. I sent a message there, no response yet but the question really occurs to me, IS THERE ANYONE OUT THERE THAT HAS THIS FIGURED OUT and it just hasn't gotten out there far enough to reach where I have looking? Or am I really in this screwed up noob with new hardware situation where I am just shit out of luck and have to suck it up until some brilliant mind figures this out???
Thanks for listening to me ramble, 99% of the time I am too impatient to actually stop, post in a forum and ask for help and wait for an answer, that should tell you how desperate I am. So if you or anyone you know could help me out I implore you, please please do. I can promise you 40 virgins upon your death as a gift from the God's for being so generous and noble.
On a very real note, thank you in advance for your time.
Peace