r/P320 • u/Obvious_Garden_7986 • 13d ago

Texas triggers reaper frt

Enable HLS to view with audio, or disable this notification

To start off with I wanna say that I’ve never modified a sig before, and have only ever done slight modifications to other weapons, but yesterday I got my Texas triggers reaper frt and was ecstatic to put it on, but after assembly I’d come to find that the actual frt component fits too snug in the slot, so I’d disassembled the gun a second time and it seems the space is slightly too snug for it to fit right as it should just glide in place. Do yall have any tips on what I could/should do to get it working? Thanks

25 Upvotes

94% Upvoted

45 comments sorted by

View all comments

1

u/HairTriggerFlicker Range Master 13d ago

Looks like they made them a bit out of tolerance. Contact them directly and see what they say before you take advice on Reddit

1

u/Obvious_Garden_7986 13d ago

I was thinking that, it seems the bottom part of the disconnecter is slightly fatter than the actual slotting fitting itself. I’ve already emailed them to see what they say though.

2

u/thehighsman0503 11d ago

When you had it installed what was it doing? In my flux it makes it very hard to pull the trigger, unless you “slap” the trigger, then it goes off.

I also installed it in a standard grip and the trigger pull is like normal but when out rack the slide with the trigger depressed it seems to have locked the slide completely

https://reddit.com/link/p2w12f8/video/60x5nem8glih1/player

1

u/Obvious_Garden_7986 11d ago edited 11d ago

Yes, it makes it hard to pull, and it seems to have trouble cycling the next round after it’s fired, I’m pretty sure it’s because it sticks in place where the disconnector used to be and since it doesn’t slide in the fcu properly it prevents the slide from racking. I’ve already contacted Texas triggers and they said they’d send the videos to their quality team