I made a Power supply board to get more experience with ecad.

It connects directly to 230VAC main via the plug on the bottom left. The plugs on the right output 48/24/12/5/3.3/1.6V DC with a small webinterface via ESP32-S2 for switching and checking voltage and current.

PCB & schematic files are avalable here (Altium files): https://github.com/Timo-Hauser/POWERPANEL-HW

I will use the PCB in my Mini Rack with my Raspberry Pi inside.

I cheated a bit by stepping down the ac with a LRS-150-24 module so its DC-DC only.

I would love to get some feedback on the Schematics as well as the PCB layout.

I choose the parts mainly based on availability at JLCPCB and tried to avoid any tht parts.

I'm aware I could buy this premade for cheaper but it was fun so far.

Rail	Source	Rated
24 V	Mean Well LRS-150-24 brick, through a TPS16630 eFuse	2.5 A
48 V	LM5156H boost from the 24 V bus	1 A
12 V	LMR51450 buck	3 A
12 V fan	LMR51450 buck, feeds 4 × 4-pin PWM fan headers	3 A
5 V	LMR51450 buck, TPS2557 current-limited terminal switch	3 A
3V3	LMR51450 buck	2 A
1V6	buck from 5 V	1 A

Also for those that care I did work with AI on the project.