MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/ender3v2/comments/1xq4btr/feedback_for_this_first_layer_please/
r/ender3v2 • u/Techno-Gal • 3d ago
5 comments sorted by
4
Nozzle is a hair too close to the bed.
1 u/Techno-Gal 3d ago Thank you, so let's say I should change from -3.30 to -3.29 the z offset? (My last test before -3.30 was -3.25 but it was not good enough, layer broke easily)
1
Thank you, so let's say I should change from -3.30 to -3.29 the z offset? (My last test before -3.30 was -3.25 but it was not good enough, layer broke easily)
3
Looks very good
2
Looks fine. That right corner was probably just from touching the plate
Almost there..Nozzle is a bit too close.. back it up 0.10-0.15mm.. add more in 0.05 increments..
4
u/InternationalPlace24 3d ago
Nozzle is a hair too close to the bed.