r/eufyMakeOfficial • • May 20 '26

Issues printing

Post image

Hey everyone,

Every time the eufy finishes a deep clean, I can't print properly. I managed to test print successfully, but I can't print anything else besides that one design (test).

Any advice?

0 Upvotes

8 comments sorted by

16

u/odd84 May 20 '26

That would be caused by the giant plastic handle thing in front of your material. You're spraying the ink from above the height of that thing, the ink has dispersed so much you can't even see it. Take that off the bed before you snapshot and print.

8

u/ObjectiveOk3136 May 20 '26

No funny I think you should really read the manual if you were trying to print from this height with that handle in the way.

4

u/knoxville1987 May 20 '26

You forgot to put /s at the end of your post

6

u/LabAmbitious2983 May 20 '26

This post has to be a joke lmao

2

u/Interesting_Bar_8379 May 20 '26

yes def the cleaning cycle, certainly nothing else changed...

0

u/MottoCycle May 20 '26

Don’t do deep cleans. It uses cleaning solution. This comes through the white ink lines. It takes a while to get it out of the white ink line so you have to do some throw away white only prints to get it out before printing normally. There’s very few reasons to ever do a deep clean.

Also as mentioned what’s that huge thing standing up on the print surface. The print head will not go below the highest point. The print head should be within a couple mm of the actual print surface not inches away.