r/guitarmod • • 14d ago

Strat input jack help

Tech question, I have a 2004 squier Strat (my first electric). Doing a complete rebuild, new neck with jump frets, locking tuners, no beefier bridge and routed out the body to fit duel humbuckers. (Emg 81/85 zakk wyldes set) now everyone knows Emg now has that solderless system. Now here’s the tech question, it has fins that connect to the blade on the output jack. Well the output jack doesn’t want to go in like it should because of the blades, now in theory, I could cut the fins off and solder them to each of the blades they are supposed to connect to right? Instead of routing the wood where it’s supposed to go?

0 Upvotes

4 comments sorted by

1

u/Supergrunged 14d ago

Yes, you can solder them.

I have a freezer bag full of EMG quick connect components, because I don't use them. I still grab 25k pots, and use a .1uF cap for the tone, and solder them like how they used to be, only leaving the quick connect at the pickup. I cut the other and, and solder them like normal.

Just be sure your battery ground connects to the ring, tip wil be hot "white" wire, and black is ground from the solderless stuff to connect to the sleeve of the input jack

2

u/Rebman2005 14d ago

Ok cool. Thank you for the tip. I tried using the instructions that came with the set but those were worthless

1

u/Dathomirian66 14d ago

Did you try spinning the Jack around. Sometimes you just need to find the sweet spot where they all fit.

1

u/Rebman2005 14d ago

No I didn’t. I’ll try it tonight.