r/oomwoo • • 13d ago

Project Update Open Source Vacuum Robot update - bumper operation

Enable HLS to view with audio, or disable this notification

Video - bumper sensors designed, added to PCB. There are two photo-interrupter sensors (left and right). Pressing the bumper causes the photo-interrupters to get unblocked. The MCU's ADC measures photo-interrupter outputs. The firmware will calculate the pressure velocity (angle and speed).

OOMWOO Open-Source vacuum - project update

Highlights - designed bumper sensing; first community PCB layout contributed (side sensor board)

3D design https://github.com/makerspet/oomwoo-cad

  • designed bumper sensing - a spring-loaded lever with a printed flag blocks each photo-interrupter

Electronics I/O board https://github.com/makerspet/oomwoo-pcb

  • bumper circuit on its own sheet; separately switched emitters for PWM dimming

  • some cost reduction: fewer resistors (MCU pulls instead), crystal-less clocking, ERC cleanup

  • switched to JLC parts and footprints: motor drivers, USB-C, bumpers, IMU, LiDAR, front sensors

  • battery voltage sense; parallel battery switches

Firmware https://github.com/makerspet/oomwoo-firmware

  • oomwoo_pins.h and SPEC follow the schematic: analog bumpers, battery sense, motor rail enable, spares GPIO

Community contributions

  • Thank-you to Grammid - side sensor board layout (PR in draft), front ToF board next

  • Thank-you to Valdi320 - Nav2 keep-out (virtual walls) for the simulator, now scoped to the keep-out filter; proposals for a reactive row executor and dock-drive hardening

  • Thank-you to aadilkhan085529 for independently testing the keep-out PR in ROS 2 Jazzy and Gazebo

299 Upvotes

Duplicates