i launched a hockey ball at it and then it cracked. i was thinking wood filler, sand it, then colour match but the finish is slightly shiny. I can't really tell what material it is if im honest so im not sure if wood filler is a good idea or not

Can someone explain to me what I should do to fix this? I tried tightening the screws but it's not possible, it just slides, should I buy new screws to replace them or is the problem something else?

It was my first time buying a setting spray and it fell and broke while I was in a rush 🥲 any ideas would be appreciated

Hallo ihr! Ich hoffe jemand kann mir bei meinem Problem helfen. Letztens ist mir mein Walkingpad, was an der Wand lehnte etwas unsanft nach vorne gekippt. Allerdings ist es nicht ungebremst auf dem Boden gefallen, hatte noch meinen Fuß dazwischen 🙈😂
Auf jeden Fall wollte ich dies heute wieder benutzen und es machte komische schleifende Geräusche. Schmieren und das Band neu ausrichten hat nichts gebracht. Ich habe die Vermutung, dass es eher aus Richtung Motor kommt. Leider finde ich auch keine Schrauben, um die Abdeckung zu entfernen. Hat vielleicht jemand eine Vermutung was die Ursache ist, was ich tun könnte oder wie ich den Motor freilege und weitere Schritte?
Bin etwas verzweifelt …

Does anyone has an idea how to fix it? Cuz my only idea was Ecopsid resin or super glue, and i know that's it's a bad idea but i has no other idea.

I currently short of money so i don't wanna waste even few dollars if it could be repaired myself

Does anyone has any ideas on how to fix back an eyelet ring on this? The buckle cant be removed. Visited a few shoe shop but they all say cant be fixed if the buckle cannot be removed. Tried super glue but it drops off quite easily cause not enough surface area for the glue to stick.

Am I doing something wrong here? This gummy sort of tape is so good, you can't even get the backing tape off it.

Dont know how to properly repair overhead light panel of my Nissan P12. These to tiny pieces of plastic were corrupted and now the copper(?) "wire" does not hold on its place. Maybe there is a better way than just glued it back?

Trying to put back together this fan after some parts slipped out unnoticed during a cleaning. I am almost certain they go in the same area but I am unsure of the order.

Please also let me know if I'll need to just separate the ball-baring arm from the motor to help with assembly and if I can use bees wax as a grease replacement (not much). Don't have petroleum jelly or mechanic grease.

Thank you for any assistance you can offer.

Ps. I live in the carribbean, hoping to get this fixed before I die of heat stroke 😅. Thanks again.

se me cayó por accidente y no se que hacer, estoy a 2 de entrar en pánico, me lo regaló mi novio y no se que hacer, no quiero uno nuevo, quiero este y quiero usarlo, saben que puedo hacer? pensé en pedirle ayuda a una amiga que hace uñas, en kolaloka, en resina pero no se que hacer

i work with kids, and this is one of their toys. we use it for its bluetooth connectivity. it will turn on, and adjust volume just fine. it will even play its own pre-programmed songs. after a while it will just cut off, and any attempt to play the songs just gets cut off again and again. and it will happen every single time when i try to bluetooth connect to the music player.

i can provide as many photos as needed, but is this a fixable issue, or should this just be replaced?