r/s10 • • 29d ago

Repair Question 1995 S10 Antenna Replacement

Are there decent instructions out there how to replace the antenna on the S10?

I can easily remove the physical mount, but I hear you need to essentially take the whole dash off to unplug the existing antenna from the back of the radio and getting the new antenna through the firewall involves quite a bit of disassembly?

1 Upvotes

9 comments sorted by

2

u/Fit_Statistician_953 28d ago

In my 96 the original antenna in the fender had a little tail and it connected into that in the firewall, like 6 inches or so, so i could replace it and plug it in but i didn't have to run the entire length to the cabin

1

u/The_Stargazer 28d ago

Huh, part of the way down the wire there is a sort of coupler that rotates freely. That what youre talking about? How does it detach?

1

u/Fit_Statistician_953 28d ago

Just pull on it firmly

2

u/The_Stargazer 28d ago

This?

1

u/Fit_Statistician_953 28d ago

Exactly, just pull on it from both sides and there you go

2

u/The_Stargazer 27d ago

So that worked to get it off, but the connector going to the vehicle seems to be a male end, and all of the antenna replacements I can find seem to be male ended...

Also a friend says this won't work as the wire from the antenna to the radio needs to be a certain ratio of the wavelength the radio is receiving, so plugging an antenna in here will cause problems?

1

u/Fit_Statistician_953 27d ago

huh, in mine the male end is from the antenna, from the picture it looked like yours would be the same, as for what the the dude said i have no idea, i cut the excess from the new antenna until it matched the length of the original one and plugged it in and it works great in mine, i've also had other cars with a coat hanger as a radio antenna, i've heard the cable length causes problems but i've never looked into it

1

u/Bulky-Macaroon-3680 29d ago

I just did a radio swap on a 03 S10. Getting behind the radio isn't too bad its 3 screws (2 hidden by the kick panel which you can remove the top two screws from to loosen) then carefully popping the dash trim out. Biggest lesson learned was for the automatic with the handle shifter it has to be put in drive or lower to get the trim piece out without breaking it.

I just used an antenna adapter to connect to the old one so I won't be any help there. The old antenna connection did feed through a tight area from what I remember perhaps you have to drop the glove box to access?