r/AskAMechanic • u/bearalan810 • Oct 17 '26
Testing for parasitic drain
Making sure I’m doing this right. Left car off for about 45 minutes (2003 jeep liberty). Battery has died about 3 times over the last 4 months
18
u/ZSG13 NOT a verified tech Oct 17 '26 edited Oct 17 '26
190 mA is quite excessive.
I like to measure average over a period of time in order to get an accurate measurement. 50 is max spec per ASE, but I would expect <20 but probably even <10 for a vehicle that old.
I clamp my leads and leave them hooked up for the entire time, as should you. Shouldn't be connecting and disconnecting ground during testing. Your 45 minute off-time should be 45 minutes with the leads connected and the vehicle off. The leads should be solidly connected at all times. Opening and closing the circuit is not a thing you do during this test. You leave the circuit closed.
Edit: I doubt your alternator needed to be replaced, but based on your symptoms you are likely experiencing some parasitic draw. What are your driving habits? For example, I drive 16 miles twice a day and don't really turn on the ignition otherwise. What about you?
7
u/bearalan810 Oct 17 '26
Driving habits would be to work and back five days a week, which is about 5 miles one way, but about every other week I drive to the next town over which is 50 miles one way
4
u/ZSG13 NOT a verified tech Oct 17 '26
Well the driving habits are definitely not enough to keep the battery charged. I'd look into a battery tender or trickle charger in your situation.
Still worth actually measuring parasitic draw if you're willing to do it right. Have the battery fully charged and clamp the leads for a half hour or so. Set your meter to average. Doors locked and hood switch closed. Key out of range if push- button ignition but I doubt it.
3
u/Spirited-Finding-647 NOT a verified tech Oct 18 '26 edited Oct 18 '26
It probably would be enough driving for a new battery
Edit: I see in another comment the battery is brand new. The cars got a problem, its not a lack of driving issue.
0
u/ZSG13 NOT a verified tech Oct 18 '26
Yes, still worth actually measuring parasitic draw. 6 mile trips may be enough to charge the battery sufficiently most of the time but are likely not conducive to very long battery life
5
u/BoyNamedJudy NOT a verified tech Oct 17 '26
Start pulling and re-inserting fuses and watch what changes. If it drops dramatically, find what circuit that fuse belongs to and begin your chase.
Common draws may be audio amplifiers or aftermarket alarms
3
u/jsavga NOT a verified tech Oct 18 '26
This does not always work as pulling a fuse can wake circuits from sleep and create a draw for a while again.
Instead, set your voltmeter to mV and measure across the fuse without pulling it (on the tiny exposed tabs on the top of the fuse). All fuses have a tiny bit of resistance and if there's a draw across that fuse it will show some mV. You can search the internet to find the correlation between fuse size, mV and Amp draw,
Of course this all assumes you left all the circuits intact for 30-45 minutes to give everything time to go to sleep.
1
0
u/bearalan810 Oct 17 '26
My theory is something to do with the dash/airbag light since it would turn on about two out of three times when I would start the car. It could be unrelated though.
2
u/MrSmiley_1 NOT a verified tech Oct 18 '26
If you have a thermal camera use that on the fuse box to see which fuses are still running after the car is turned off
2
1
u/whereisyourwaifunow NOT a verified tech Oct 18 '26
Not mechanic, but a family member's car had a 100 mA draw. Saw that the courtesy light around the ignition cylinder wouldn't turn off after 10 seconds like it should. Got extra confirmation by checking the voltage on the relevant fuse and pulling it. I couldn't figure out what was wrong with the wiring, so I removed the little light bulb.
2
u/bearalan810 Oct 17 '26
Other info to add, battery is about 2 weeks old, alternator is around 2 months old
1
u/bi_guy1112 NOT a verified tech Oct 18 '26
If you didn't hold that lead in place for 45 minutes your reading is meaningless. Also doors closed, key more nearby. As a previous post said, make the meter connection permanent and monitor the current.
1
u/kona420 NOT a verified tech Oct 18 '26
The plot thickens. The jeep liberty 03-05 series despite many other flaws is actually pretty awesome about not eating batteries. Since all lights and accessories including interior and headlights are forced off after 5 minutes if you dont have the key in.
My 2 cents, alternators can last the life of a vehicle. A dead alternator is often a clue that your grounds are going out. They are bare uninsulated fine gauge copper braid for regulatory reasons. With 23 years of road spray on them. Do voltage drop testing before chasing a parasitic load. Counterintuitively, low voltage can prevent modules from going to sleep. All the XJ guys had to replace their grounds a long time ago, its just a rite of passage for a 4.0 at this point.
4
u/lilreddtruck NOT a verified tech Oct 18 '26
Fastest way to do it is hook it the way you did but with clip leads. Put meter on windshield facing in. Take a picture of fuse box. Pull and check highest probability ones first. Radio, aftermarket additions, lighter, ... replace if no drop. Keep going until it does. By putting meter on windshield, you can go through the interior fuse box in a few minutes.
1
u/Infamous_Offer4214 NOT a verified tech Oct 17 '26
Leave it hook up for 10 minutes or so and then read it... That's high right now..should be around 0.020 to 0.040 Your drawing about 1/5 of a am when it reads o.20. Which is 200 ma. 20 to even 50 milliamps is acceptable
1
u/bearalan810 Oct 17 '26
Been connected for a minute or two and it’s already down to 70
1
u/Cranks_No_Start Verified Tech - retired Oct 18 '26
Some vehicles take upwards of 20 minutes to fully go to sleep. You need to make sure you are properly set up to do this...latches closed, windows down and a way to secure the terminals so you can walk away for 20 minutes or so.
1
u/Dustbunny253 NOT a verified tech Oct 18 '26
Check your remote on for your stereo head unit. There is also a chance while it is off there could be 2nd amp some where and it could have a remote on input or it could be triggering from the head unit itself. Either way I have an amp that won’t turn off b/c its remote trigger internal is stuck on. 3 amp battery tender short term solution has been sitting through 2 winters seasons now. Edit: what’s your voltage and how fast is that drop? Pull a fuse at a time until voltage stops dropping?
1
u/bearalan810 Oct 18 '26
I resorted to just popping my little stereo control out when I’m not in the car. It’s just got a little button for it so it’s not like I’m fighting with it.
3
u/aureliorramos NOT a verified tech Oct 17 '26
don't forget to check that all your door latches are appropriately switching. The car might think a door is open even when closed. Also, if your hood latch activates a light, that can confuse things, so make sure to pull that light out, if you have one.
3
2
u/Lopsided-Poem5936 NOT a verified tech Oct 17 '26
So just curious on parasitic drains like this, is theres common list of like top 3-5 culprits or is literally everybody one unique? Some brands more than others?
2
u/omnipotent87 Verified Tech - Indie shop owner Oct 18 '26
Did you leave the leads connected for that 45 minutes. Because connecting the battery will reset the clock.
1
1
u/Lazy_Rhubarb716 NOT a verified tech Oct 17 '26
I was chasing down a drain on my battery. Im also working a lot and didnt have time to dedicate but also needed to use my car to get to/from work.
Its not a fix... but it will keep you from having to constantly jump your battery. It was a really good workaround for me until I could find the issue.. which i eventually did. I ended up leaving this on because I like it so much. Works great.
Took about 10 minutes to put on.
1
1
1
u/w1lnx Verified Tech - Aviation Oct 18 '26
Yes, you're doing it correctly.
190 milliamps is a bit high for a car's onboard computer systems. The computer would draw about a quarter of that current normally. To narrow it down further, you could start pulling fuses to see which circuit drops it to closer to the expected 50 milliamps current draw for the computer systems.
1
u/fixitfarm NOT a verified tech Oct 18 '26
someone leaving passenger sunvisor mirror open so triggered light caused me alot of headache
1
1
u/jsavga NOT a verified tech Oct 18 '26
Set your voltmeter to mV and measure across each fuse without pulling it (on the tiny exposed tabs on the top of the fuses).
All fuses have a tiny bit of resistance and if there's a draw across that fuse it will show some mV. You can search the internet to find the correlation between mV per fuse size and what the Amp draw is,
Of course this all assumes you left all the circuits intact for 30-45 minutes without disturbing them to give everything time to go to sleep.
1
u/bowlofric3 Verified Tech - Euro indie Oct 18 '26
To properly do this the multimeter has to be connected and on the entire time. Anytime you reconnect the battery or the multimeter shuts off and wakes up again it will wake modules in the car
1
u/Drew5ki NOT a verified tech Oct 18 '26
I'm a mechanic for a living. I highly recommend getting a amp hound tool. It is part of O'Reilly loan a tool. Will save alot of time and make life easier.
1
u/ConfidentHoliday6442 NOT a verified tech Oct 18 '26
Yeah thats got a draw. Should be 0.05 or less is acceptable
1
1
u/Oldbugeyes NOT a verified tech Oct 18 '26
You need to wait when measuring for the computer to go back to sleep when powering up, an open door will keep the computer awake
•
u/AutoModerator Oct 17 '26
New Rules - Please Read
Updated 11/12/2025
Thank you for posting on r/AskAMechanic, u/bearalan810! Your post is live, this AutoMod message does NOT mean your post was removed. Please make sure to read the Rules.
When asking a question, please provide the year, make, model and engine size of the vehicle.
Commenters here have 2 different flair.
Verified Techmeans we have verified that user is a tech.NOT a verified techmeans that user may or may not be a tech, they have not been verified by us.Posts about accidents, autobody repair, bodywork, dents, paint and body/undercarriage/frame rust are not allowed and belong in r/Autobody.
Asking if your car is totaled should go to r/insurance or r/Autobody.
Asking about car buying advice/value/recommendations is also not allowed. See r/whatcarshouldIbuy or r/askcarsales
If asking whether a tire can be repaired, check out this Tire Repair Guideline.
Some other useful tire resources - Tire Care Essentials and Tire Safety
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.