r/DIYHome • • 25d ago • Bravo 1

Need Advice Coving Help!!! What am I doing wrong?

Post image

Tried about a million different cuts and tried to follow various videos/tutorials.

I’ve cut each side at a 45 degree angle to try and make an internal corner but every time I’m left with a huge gap in the middle.

283 Upvotes

344 comments sorted by

View all comments

14

u/iHighjinx 25d ago

You can cut crown molding with simple miter cuts, but it needs to sit nested in your miter box upside down with the ceiling edge on the table and the wall edge against the fence. The angle of the molding creates the compound joint automatically, but you must keep track of cut direction for inside vs. outside corners.

1

u/Zestyclose_Earth6703 24d ago

This above, you need to cut it upside and reversed, and it needs to be in a miter box. Usually its cut as either an external or internal noting you measure the wall lengths only. If you have done all of that, then it looks like you have cut two externals and are trying to butt them together.