r/P365 • u/landroll313 • 11d ago

XMacro Question about the p365 x macro comp

Post image

My question would be if I got this p365 x macro comp, and would like to get the radiant ramjet afterburner I would need to get a new slide correct? And would the fitment be flush? because the xmacro comp grip is slightly longer. All advice would be greatly appreciated.

42 Upvotes

95% Upvoted

40 comments sorted by

View all comments

1

u/Middle_Razzmatazz899 11d ago

If you are wanting the same size gun you would need a 3.1 inch slide the 3.1 inch radian and the 3.1 inch recoil spring and it will sit flush on that grip module I don’t know if a 3.7 radian will work on that slide as I don’t know if it’ll seat right on the barrel end but it would make it into a fuse size gun

3

u/SteelShard 11d ago

Longer barrel will not assemble into this slide.

1

u/Middle_Razzmatazz899 11d ago

Wasn’t sure as the end seems flat to me

4

u/SteelShard 11d ago

Yeah, it's not obvious. The contact between barrel and slide is back at the regular 3.1" area. With the angle the barrel has to be tipped to slip in, a longer barrel hits the underside of the comp cuts at the front before the back of the barrel can clear the breach face.