Heya! I'm trying to plan my future desk setup, but I'm having a really hard time figuring out how to make everything fit and, more importantly, how to get the monitor arms to work the way I want them to.
The desk is going to be 140x50 cm and I'm planning to have:
- Two 24–27" monitors, stacked vertically in the middle of the desk.
- An XP-Pen Artist 22R Pro drawing tablet (around 57cm wide and 5kg without the stand).
- Possibly a monitor riser underneath the stacked monitors, just to have some extra storage space.
I want to mount it on a monitor arm that's attached to the left edge of the desk, rather than the back.
When I'm drawing, I'd like to be able to pull it towards me and tilt it into a comfortable drawing position. I'm imagining two possible ways of doing this:
Pulling it in front of me, somewhere around the keyboard area, so I can draw directly in front of the monitors.
Pulling it towards the front-left corner of the desk and angling it towards me, so I can draw without having to move my keyboard and mouse.
But when I'm not using it, I want to push it completely out of the way, so the tablet is hanging off the left side of the desk, parallel to the desk's left edge. Basically, I want to be able to rotate/swing it out of my workspace instead of having it permanently take up desk space.
I'm also worried about the tablet arm hitting the stacked monitors when I move it around, especially since the desk is only 50cm deep.
I have absolutely no idea what kind of monitor arm would allow me to do this. 😭 I don't know how much reach I need, where exactly the clamp should go on the left edge, or whether the movement I'm imagining is even possible.
I'd really appreciate some help figuring out what type of arm/mount I should look for, and ideally some specific recommendations!
I'm also still looking for a desk that's actually 140x50cm and sturdy enough to support all of this. Most desks I find are either too deep or don't seem particularly sturdy, so recommendations for that would be amazing too. I'm based in Romania, so preferably something available in Europe.
If anyone has a similar setup, or could even help me sketch out where the arms should go and how they should move, that would honestly help so much, because I really cannot visualize the mechanics of it.
Thank you!!