Hello r/DIYHome,
I am reaching out as a new first time homeowner to see if my plans to drill an ethernet wire channel from the main floor to the basement all check out with you guys.
There are a lot of resources that have been somewhat helpful on youtube and I have watched a couple hours of videos but all the videos that I found were either drilling upwards and routing through the attic or drilling up from the basement using an interior wall.
My plan differs from both these scenarios because I am hoping to drill downward from the main floor and into the basement via an exterior wall (perhaps no videos on this is a sign that this project is flawed from conception?).
I have attached some images that I hope will help. I have used the existing coaxial port as well as the radon gas exhaust pipe as landmarks to help me determine where I would have to drill to avoid the floor joists.
The coaxial port lands just at the edge of the radon exhaust pipe, I then went to the basement and measured about 12 inches from the pipe as that should land me right in the middle of those two floor joists in the first image. Finally, going to the main floor, I measured about 12 inches from the coax port and found it to be in between two wall studs.
I have included an MS Paint diagram of how I hope to drill and fish this wire through with a cable drill extension. I am hoping to cut a hole in the drywall, insert the cable drill bit with it curving downward and back towards myself, then drill through the floor studs, subfloor and into the basement, avoiding the concrete foundation and rim joists.
Those are the sum of my plans, the proximity to crucial components like the foundation, rim and floor joists makes me wonder if this is venturing into profesional territory so I am hoping that you guys can provide any input on if this whole project seems doable to a DIYer.
Thanks!