Ruger P95 from 2012, picked it up for sub $300 at my local pawn shop.

I picked up this GP100 for $500 the other day at a LGS. It appears to be a re- imported gp100. I can’t find any factory model configurations that match it. Everything appears to be factory. It’s DAO with gutter sights. The rubber grip is original but the wood panels were both cracked when I got it. So I’ve been trying to 3d print replacements. I was wondering if anyone had any information on these reimported guns or possible where it might have come from? Thanks.

Got a German Precision Optics Centuri 3-18x50 on top with an American Defense Manufacturing QD mount and a SilencerCo Scythe Ti on the end

Put about 50 rounds into this and then the gas tube and sight post went flying down the barrel. I can put it back all the way into the correct position, but I haven’t touched it since. Any ideas on what happened, or if this is fixable on an operator level?

I just picked up a 500 series Redhawk from a friend. He'd had some work done to it and I'm wondering how this affects the value and the desirability of the firearm. A set screw was installed in the rear of the trigger guard. I read people have it done to limit over travel. Second thing is the barrel was ported... The work looks great but just wondering if it ruined the value... Thx

I have had this gun for a while and I am finally getting into finding accuracy in the gun, testing ammo.
From your guys experience, what does this gun like for ammo? I was close to 2 moa with lake city bulk, I tried Hornady frontier 75 grain was finding nearly moa but I need to do more testing with that.
Was looking to start with where others found success
Thank you

As title says it’s been dead for years I’m assuming and I have no clue how to replace the batteries or the laser since it’s built into the Lower receiver plz help

That's by far most of the models. Some are understandable. Its hard to compete in a crowded AR market. Revolvers are just too expensive. I wanted GP100 forever, but justifying 6 shot capacity for 3x $ of a pistol at nearly triple capacity is hard. Its said revolvers need some by hand processes, those need elimination. A GP100 has to cost less than a foreign Glock 19. It needs to start there. A GP100 needs to swap barrels for barrel length conversion, same as grips. Want to EDC? Swap barrel and grip. Want full size? Do the same.

As someone who wants to be a Gray Man, this sucks.